How to Configure Nodegrid Serial Ports

How to Configure Nodegrid Serial Ports

To configure the serial ports of your Nodegrid Serial Console, follow the guideline steps below.

 

WebUI

  1. Log in as admin to the Nodegrid Serial Console Web interface.
  2. Go to Managed Devices page.
  3. Select the serial ports you want to configure, or check the top checkbox, to select all serial ports, then click on Edit.
    Note: the configuration of the first serial port from the multiple selection will be displayed, and only changed field(s) will be saved.
  4. Make the necessary changes according to your needs:

  • set baud rate
  • set mode to Enable
  • Check/Uncheck:
    • Enable Hostname Detection
    • Multisession
    • Read-Write Mutisession
    • Skip authentication to access device
    • Show text information
    • Enable IP Alias
    • Data Logging
    • Allow SSH protocol
    • Allow Telnet protocol
    • Allow Binary socket

5. Save the changes

 

CLI

1. log in as admin via ssh or console port

2. type the following commands:

[admin@nodegrid /]# cd /settings/devices/

[admin@nodegrid devices]# edit -

and set parameters you want:

[admin@nodegrid {devices}]# set

address_location=                            flow_control=

allow_binary_socket=                       icon=

allow_ssh_protocol=                         mode=

allow_telnet_protocol=                      multisession=

baud_rate=                                      parity=

coordinates=                                    power_control_key=

data_logging=                                  read-write_multisession=

enable_data_logging_alerts=             show_text_information=

enable_hostname_detection=             skip_authentication_to_access_device=

enable_ip_alias=                               ssh_port=

escape_sequence=                            telnet_port=

 

once all parameters are configured, type:

[admin@nodegrid {devices}]#commit


    • Related Articles

    • Nodegrid Serial Console: Pinouts, Cables and Connectors

      The tables below show the serial port pinout information of the NSC TxxR (Cisco Pinout) and NSC Txx (Legacy Pinout).  NSC TxxR - Cisco-like Pinout Pin Signal Name Input/Output 1 CTS IN 2 DCD IN 3 RxD IN 4 GND N/A 5 GND N/A 6 TxD OUT 7 DTR OUT 8 RTS ...
    • Power Control within Serial Session

      Nodegrid Serial Console features the Power Control integration which gives authorized users the ability to power on, power off and reset/reboot the serial devices, within the serial session, by using an escape character (default escape character is ...
    • How to Telnet and SSH to the Nodegrid Serial Ports

      Note: by default, Telnet access is turned off with your Nodegrid Serial Console. Authorized users can use Telnet or SSH to connect directly to the console of a managed device if all of the following are true: Telnet / SSH protocol is enabled under ...
    • How to build the set-up for Virtual Serial Ports communicating to an end device, via the Nodegrid OS

      Abstract: In the industry, some legacy applications impose to use serial ports (COM) to interface with the industrial automates. In this article, we will study a set-up in which a desktop emulates a virtual serial COM, and conveys the connection via ...
    • How to Configure Network Bridge on the Nodegrid Serial Console

      Nodegrid Serial Console cascades, or daisy chains, network ports by implementing a network bridge between ports ETH0 and ETH1. In this configuration several NSC units can be used in cascade mode, all sharing the same network switch port, saving a ...